WorldNet Knowledgebase

Step-1: Connect the Router

(1) Turn off the modem (ONT): The modem refers to the Optical Network Terminal (ONT), commonly known as the fibre box.

(2) Connect the modem (ONT) to the router's WAN (Internet) port using an Ethernet cable.

(3) Turn on the modem (ONT): Wait approximately 2 minutes for it to restart.

(4) Power on the router: Connect the router to a power source and switch it on.

Step-2: Access the Router

Option-1: Wired Connection: 

Connect your computer to the router using an Ethernet cable via the router’s LAN port. Ensure your computer has an Ethernet port.

Option-2: Wireless Connection:

Locate the SSID (Wi-Fi name) and password printed on the label at the bottom of the router.

Step-3: Configure the Router

(1) Open a web browser (e.g., Chrome, Safari, Firefox) and enter the default gateway address (e.g., 192.168.1.1).

Ensure your computer is connected to the router (via LAN or Wi-Fi).

(2) On the login page, enter the default credentials:

Username: admin | Password: admin

(3) Navigate to:

[Basic] > [Link Interface] > [Fibre]:

VLAN ID: -1 (Note: “-1” indicates no VLAN.)

802.1P: -1 (Linked to VLAN ID settings.)

[Basic] > [WAN]:

WAN Connection: New (Connection Type: Not PPP > Dynamic/DHCP or IP Routing IP)

WAN Connection: Enabled (tick the box)

Service List: Internet (tick the box)

Note that TR-069 (Technical Report 069) is known as the CPE WAN Management Protocol (CWMP). It is used for remote management and configuration of Customer Premises Equipment (CPE). Normally untick the TR069.

Step-4: Setup Completion
Once the above steps are done, your setup is complete.

Step-5: Test Internet Connection
Confirm the connection by browsing the internet or running a speed test.

If you encounter any issues or have further questions, please don't hesitate to contact us.

| Reference

- Setup Router: https://setuprouter.com/router/huawei/hg630b/screenshots.htm