WorldNet Knowledgebase
VoIP ATA Setup Guide: Grandstream HT80x
(1) HT801 Back Panel
(2) HT802 Back Panel
| Analog Telephone Adapter (ATA) is a device for connecting traditional analogue telephones to a voice-over IP (VoIP) telephone network.
Step-1. Connect the ATA device
(1) Insert a standard RJ11 telephone cable into the phone port and connect the other end of the telephone cable to a standard touch-tone analog telephone.
(2) Insert the Ethernet cable into the internet or LAN port of the HT801/ht802 and connect the other end of the Ethernet cable to an uplink port (a router or a modem, etc.)
(3) Insert the power adapter into the HT801/HT802 and connect it to a wall outlet.
Step-2. Access the ATA device
(1) Check the IP address of the ATA device
- Press *** (press the star key three times) to access the IVR menu and wait until you hear "Enter the menu option".
- Press 02 and the current IP address will be announced (e.g. 192.168.1.100).
(2) Open a web browser and type the IP address
Step-3. Setup the ATA device
(1) Enter an admin password (default: admin) if necessary.
(2) Register a SIP Account
a. Go to FXS port (1 or 2) pages.
b. In FXS port tab, set the following:
=================================
Account Active: Yes
Primary SIP Server: sip.feenix.co.nz
SIP User ID: {Phone Number}
Authenticate ID: {Phone Number}
Authenticate Password: {Unique Password}
Name: (optional)
=================================
Step-5. Check the status
Note that if it displays Registered, it means that your account is fully registered, otherwise it will display Not Registered so in this case you must double check the settings or contact us.
Step-6. Test it
- All configurations are complete. Pick up the phone handset and listen for the dial tone.
| Official document:
https://www.grandstream.com/hubfs/Product_Documentation/ht80x_user_guide.pdf